Analysis of Mechanical Factors at Deep Cultivation

Authors

DOI:

https://doi.org/10.20535/ibb.2019.3.1.146895

Keywords:

Microorganisms, Deep cultivation, Mechanical stress, Shear stress, Micromycetes, Recombinant bacteria

Abstract

Background. During the passage of technological processes, microorganisms are prone to the influence of various technological parameters, such as changes in temperature, pH of the culture medium, chemical, biological, and mechanical influences. To date, the degree of study of these effects is different. One is almost fully covered, while others are practically not studied at all. In some cases, the study of one factor leads to the emergence of new tasks and nuances in the study of others, since they are all inextricably interconnected. One of the least studied, but the most critical are mechanical effects. It has been unequivocally established that the rotation speed and the design of the mixing device affect the final product yield, but the nature and mechanisms of this effect remain unknown.

Objective. The aim of the paper is to find out the effects of mechanical factors on microorganisms in the process of deep cultivation, in particular on recombinant bacteria and micelles, since they are the most sensitive to these factors, using literary data. And, on this basis, tasks for further research should be formulate.

Methods. The research of scientists from different countries on the effects of the mechanical effects of mixing on microorganisms in the process of deep cultivation is studied and analyzed.

Results. According to the literature data, dependencies of stirring rate on growth and microorganism status have been established, and recommendations for optimal mixer speeds for specific types of bacteria and micelles, which require further experimental confirmation, are provided. It has been found that increasing the size of cells increases their sensitivity to mechanical influences. The analysis of litera­ture has shown that viscosity decreases with increasing mixing intensity, which imposes a certain imprint on the kinetics of the process. It was detected that in conditions of deep cultivation with mechanical mixing the mycelial fungi, in contrast to bacterial organisms, is divided into relatively small segments that retain the ability to reproduce and accumulate biomass.

Conclusions. The analysis of literature data showed that the mycelial fungi are the most sensitive to mechanical factors during deep cultivation. The optimum mixing speed for them is 120–150 rpm. It is necessary to modernize the design of the mixing device to optimize this process, to ensure the supply of nutrients and oxygen to all cells during deep cultivation in sufficient quantity for their development.

References

Bekker ME. Introduction to biotechnology. Moscow: Pishhevaja promyshlennost'; 1978. 228 p.

Barabash VM, Begichev VI, Belivickaja MA, Smirnov NN. Problems and trends in the development of the theory and practice of mixing of liquid media. Teoreticheskie Osnovy Himicheskoj Tehnologii. 2012;2:140-7.

Tishin OA, Ostrovskaja TV, Devkin AV. Experimental study of the mixing process in the apparatus with a mixer. Izvestija Volgogradskogo Gosudarstvennogo Tehnicheskogo Universiteta. Ser. Reologija, Processy i Apparaty Himicheskih Tehnologij. 2012;2:88-90.

Golovanchikov AB, Cherikova KV, Shul'gina AG. Simulation of the mixing process in devices with combined mixers. Izvestija Volgogradskogo Gosudarstvennogo Tehnicheskogo Universiteta. 2016;2:11-4.

Kolmogorov AN. Mathematical models of the turbulent motion of incompressible viscous fluid. Russian Math Surveys. 2004;59(1):3-9. DOI: 10.4213/rm697

Verschuren ILM. Feed stream mixing in stirred tank reactors. Eindhoven: Technische Universiteit Eindhoven; 2001. DOI: 10.6100/IR547715

Vicum L. Investigation of the influence turbulent mixing on precipitation processes carried out in stirred tank reactors [dissertation]. Zurich: Swiss Federal Institute of Technology; 2005. DOI: 10.3929/ethz-a-005069682

Samujlenko AJa, Raevskij AA, Pavlenko IV, Eremec NK, Bobrovskaja IV, Kanarskaja ZA, et al. The influence of cultivation methods on the yield of bacterial mass and the quality of vaccines for veterinary medicine. Vestnik Kazanskogo Tehnolo­gicheskogo Universiteta. 2013;9:23-8.

Karaeva JuV, Trahunova IA, Halitova GV, Daminov AZ. Evaluation of the quality of mixing in methane fermentation reactors. Vestnik Kazanskogo Tehnologicheskogo Universiteta. 2012;10:61-6.

Motronenko V, Ruzhynska L, Chumak V, Galkin O. Evaluation of mechanical agitation effect on microscopic filamentous fungi culturing efficacy. Proceedings of the National Aviation University. 2017;2:108-14. DOI: 10.18372/2306-1472.71.11754

Men'shutina NV, Guseva EV, Nizhegorodova TA, Budran Zh.A. Stress of microorganisms in membrane bioreactors under the influence of mixing. In: Proc VII Conf Biology – the Science of the XXI Century; 2003; Pushhino. p. 119.

Joshi JB, Elias CB, Patole MS. Role of hydrodynamic shear in the cultivation of animal, plant and microbial cells. Chem Eng J. 1996;62(2):121-41. DOI: 10.1016/0923-0467(95)03062-X

Sarra M, Ison AP, Lilly MD. The relationships between biomass concentration, determined by a capacitance-based probe, rheology and morphology of Saccharopolyspora erythraea cultures. J Biotechnol. 1996;51(2):157-65. DOI: 10.1016/0168-1656(96)01612-4

Silva-Santisteban BOY, Filho FM. Agitation, aeration and shear stress as key factors in inulinase production by Kluyveromyces marxianus. Enz Microb Technol. 2005;36(5-6):717-24. DOI: 10.1016/j.enzmictec.2004.12.008

Jung JY, Park JK, Chang HN. Bacterial cellulose production by Gluconacetobacter hansenii in an agitated culture without living non-cellulose producing cells. Enz Microb Technol. 2005;37(3):347-54. DOI: 10.1016/j.enzmictec.2005.02.019

Kljushina AM, Karlova AF, Leont'ev VK. The study of the process of mechanical mixing. In: LXXI All-Russian Sci Tech Conf of Students, Undergraduates, and Postgraduates of Higher Educational Institutions with International Participation; 2018. p. 627-30.

Nemanova EO, Rusinova TV, Gorshina ES, Bіrjuvov VV. The choice of regime parameters in the submerged cultivation of the mycoprotein producer. Izvestiya MGTU "MAMI". 2013:4(1):271-7.

Trahunova IA, Karaeva VJu. The effectiveness of hydraulic mixing with different methods of loading the organic substrate in the reactors of BGP. Young Scientist. 2012;4:45-50.

Karpov AA. Scaling up the processes of submerged cultivation of microorganisms in bioreactors [dissertation]. Shchelkovo; 2004. 122 p.

Vladimirova IS, Emel'janov VM, Filippova NK, Koshkina LJu. Intensification of the processes of aerobic cultivation of microorganisms. Vestnik Kazanskogo Tehnologicheskogo Universiteta. 2009;2:19-27.

Arhipov MJu. Development of a combined mixing system for the cultivation of aerobic mycelial microorganisms [dissertation]. Moscow; 2005. 165 p.

Smirnov RS. Hydrodynamics and mass transfer in large-scale bubbling apparatus with mechanical agitation [dissertation]. Moscow. 1985.

Dudka IA, Vasser SP, Jellanskaja IA. Methods of experimental mycology. Kyiv: Naukova Dumka; 1982. 550 p.

Sekova VJu, Kornilova NA, Vasil'eva AV. Deep cultivation of the entomopathogenic fungus Beauveria bassiana. Uspehi v Himii i Himicheskoj Tehnologii. 2010;11:42-5.

Ustinnikov BA, Ivanov VV, Georgievskij GP, Kaukin MG. Optimization of mixing of the culture fluid during deep cultivation of microorganisms. Fermentnaja i Spirtovaja Promyshlennost'. 1987;5:54-8.

Published

2019-03-28

How to Cite

1.
Serbov V, Motronenko V. Analysis of Mechanical Factors at Deep Cultivation. Innov Biosyst Bioeng [Internet]. 2019Mar.28 [cited 2024Mar.28];3(1):45-51. Available from: http://ibb.kpi.ua/article/view/146895

Issue

Section

Articles